Winding machine installation: sp-d102-b-6
Economical winding machines are divided into different specifications according to the size of the power, according to the different winding machine motors, divided into DC brushless motors and AC variable frequency motors, but according to the different applications, they are divided into the following types:
The first type is a transformer winding machine, which is characterized by being able to wind several different enameled wires at the same time, but there is no better tension controller, and its tension control is only controlled by the degree of compression of the wool felt.
The second type is the general coil winding machine, which is mainly used for the general coil of a single enameled wire. The standard tension controller is used. Its standard tensioner has a larger range. In the occasions where the tension requirement is not high, as far as the tensioner is concerned, it The diameter of the enameled wire can range from 0.2-1.4mm.
The third type is a magnetic damping wire frame winding machine, which is also suitable for the general coil of a single enameled wire, but its tensioner uses a magnetic damping tensioner, from 0.03mm diameter enameled wire to 0.5mm diameter enameled wire, which is divided into There are many specifications. The advantage is that it has relatively stable tension and can be used to wind thin enameled wires. The disadvantage is that enameled wires with a diameter of 0.03mm-0.5mm require a variety of tensioners.
The fourth type is the motor coil winding machine, which is mainly used for winding the motor coil. The torque of the winding machine is large. The tensioner uses a standard mechanical tensioner, but it is equipped with a wire die.
The following video shows the installation of a general coil winding machine.
Setting of counting direction of winding machine controller:
The REPOSAL's winding machine controller has complete functions and a wide range of applications.Some customers have purchased our winding machine controller.As soon as we delivered the counting sensor, users sometimes find that when they are installed in the winding machine, the counting It will start counting from 9999.9 and become smaller and smaller. This is just because when you don't pay attention, install the counter in the opposite direction.At this time, we don't actually need to disassemble the installed machine. We have taken this into consideration. You need to change the counting direction on the controller.The video below shows that if you use our winding machine controller to change the counting direction.
Instructions for use of magnetic damping tensioner for winding machine